Falcon – F48V5 Differential – Ready 2 Run (FREE SHIPPING)

This full build comes with Build Falcon Controller F48 Controller and (1) Meanwell 350-watt 5V power supplies in a YPS Metal Enclosure with FREE SHIPPING. These are ready to run, no need for additional work besides setting up in xLights.DocumentationSpecification SheetDescriptionF48V548 Differential Outputs. Bi-Directional communication with all version 5 receivers connected in Smart Receiver Mode. The receivers report voltage, port current, firmware version, pixel counts and other useful information. Version 5 receivers can be updated over the wire. Can drive up to 32768 pixels from E131, DDP or Artnet (No restriction on the input type).  Embedded local SmartReceiver. Can connect up to 12 Falcon Differential SmartReceiver Chains.Board current specsFeatures Bidirectional Communication with version 5 receivers.Embedded SRx1 V5 SmartReceiver.192 Universes of E131, Artnet or DDP. No restrictions, same amount for all types of input.2-Port Switch to “Daisy-Chain” controllers.Wireless ESP-07 Module with board mount antenna. Optional external antenna can be ordered.Falcon Player Remote Mode. The controller can store sequences on micro SD card and play in sync with FPP master.Single 4-Layer Board.Ability to drive 12 SmartReceiver chains.Power Board can be powered from 5 or 7 – 13V, 3 amp minimum power supply.Local SmartReceiverBuilt-In local SmartReceiver. Ports 1-4A are the local SmartReceiver Ports.Number of ports 48 Ports. All ports can use any of the 98,304 channels this controller can receive as a start address. Each string can be independently configured for null nodes, zigzag, forward/reverse, node type, pixel count , grouping etc…Pixels per port 1024 maximum per port when in 32 port mode. 704 maximum per port when in 48 port mode.Pixel TypesSupported Pixel TypesDMX and Renard Outputs1 – Dedicated RS-485 output. 1 RJ-45 connector.LCD Display,Push Buttons and Indicators .96″ OLED 128×64 matrix display for setup and status. 5 – Push buttons to control display. Up, Down, Right, Left and Select Power LED indicator Two multi purpose LEDS for status.Temperature Sensors1 – Processor temperature sensor. 1 – Additional Sensor